PODS Re-zero Procedure

You should perform PODS Re-zero procedure after service or replacement of any parts related to the passenger seat.

1. Ignition "OFF", connect GDS.
2. Ignition "ON" & Engine "OFF", select Airbag system and "PODS Reset" mode.
   Fig 1: Display - PODS Reset Mode Screen

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 2: Display - Register Screen

   Courtesy of HYUNDAI MOTOR AMERICA
3. The GDS will show the two PODS RESET function steps.
   1. Erase PODS diagnostic codes.
   2. PODS initialization.
      Fig 3: Display - PODS Initialization Screen

      Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: This step must be done PODS re-zero, when the front passenger seat is empty.
4. Press the OK button to erase the PODS related diagnostic codes.
   Fig 4: Display - PODS Related Diagnostic Codes Screen

   Courtesy of HYUNDAI MOTOR AMERICA
5. Press OK button to initialize the PODS.
   Fig 5: Display - PODS OK Button Screen

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: This step must be done PODS re-zero, when the front passenger seat is empty.
6. The PODS initialization procedure will be performed.
   Fig 6: Display - PODS Initialization Procedure Screen

   Courtesy of HYUNDAI MOTOR AMERICA
7. Check PODS situation with selecting "Pass. Airbag Real-time Info" after performing PODS Reset procedure.
   Fig 7: Display - Pass. Airbag Real-time Info Screen

   Courtesy of HYUNDAI MOTOR AMERICA
8. Perform inspection with pressing OK button.
   Fig 8: Display - Passenger Airbag System OK Button Screen

   Courtesy of HYUNDAI MOTOR AMERICA
9. Finish the procedure with pressing cancel button if there is no problem after inspecting each status as below.
   Fig 9: Display - Passenger Airbag System CANCEL Button Screen

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 10: Display - Passenger Airbag Status Screen

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 11: Display - Passenger Airbag Status Screen

   Courtesy of HYUNDAI MOTOR AMERICA