LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2012 >> Equus Signature >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) & Sensors >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Installation

CAUTION:
  • Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
  1. Install the Front Impact Sensor.
  2. Connect the Front Impact Sensor connector.
  3. Tighten the Front Impact Sensor mounting nut.

    Tightening torque: 

    5.9 ~ 6.9 N.m (0.6 ~ 0.7 kgf.m, 4.3 ~ 5.1 lb-ft)

  4. Install the radiator grille upper cover and air duct assembly.
  5. Reconnect the battery negative cable.
  6. After installing the Front Impact Sensor, confirm proper system operation:
    1. Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals