September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Signal Circuit Inspection

NOTE: Check for open or short circuit in harness. Refer to Signal Waveform & Data in the "General Information" procedure

Check for short to battery in signal circuit
1. Disconnect PCM connector
2. Ignition "ON" & Engine "OFF"
3. Measure voltage between signal terminal 1 of TPS harness connector and chassis ground
  Specification : Approx. 0 V
4. Is voltage within the specification?
  YES
  - Go to next step as below.
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check for open in signal circuit
1. Ignition "OFF"
2. Measure resistance between signal terminal 1 of TPS harness connector and TPS signal terminal 41 of the ECM harness connector.
  Specification : Approx. 0 Ω
3. Is resistance within the specification?
  YES
  - Go to next step as below.
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.