LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2012 >> Elantra Touring GLS, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Inspection Chart For Diagnostic Trouble Codes (DTC) >> P0708: Transmission Range Sensor Circuit High Input >> Component Inspection
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Component Inspection

  1. Ignition "OFF".
  2. Remove "TRANSAXLE RANGE SWITCH".
  3. Measure the resistance between each terminal of the sensor.

    Specification  : approx. 0 Ω (refer to "RANGE SWITCH CONTINUITY CHECK TABLE " below)

    [RANGE SWITCH continuity check table (Case of SPORTS MODE vehicle has no 3, 2, L range)] 

    TRANSAXLE RANGE SWITCH RANGE CHART

    Range Terminal
    P R N D 3 2 L
    1       •      
    2           •  
    3 •            
    4     •        
    5         •   •
    6              
    7   •          
    8 • • • • • • •
    9 •   •        
    10 •   •        
  4. Is resistance within specifications?

    YES 

    • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals