Repair Procedures: Installation
- Install the OCS equipped seat cushion.
(Refer to SEAT & POWER SEAT
- Install the front seat assembly. (Refer to SEAT & POWER SEAT
- Reconnect the battery negative cable.
- After installing the OCS, confirm proper system operation : Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.
Telltale lamp will turn on for 4 seconds and be turned off for 4 seconds. After the 8 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
NOTE:
Be sure to perform OCS (PODS) reset with Hi-Scan (Pro) after replacing OCS equipped seat cushion.