LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2011 >> Azera GLS >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) & Sensors >> Front Impact Sensor (FIS) >> Repair Procedures >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Repair Procedures: Installation

CAUTION:
  • Be sure to install the harness wire not to be pinched or interfere with other parts.
  • Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
  1. Install the new Front Impact Sensor with the nut then connect the SRS harness connector to the Front Impact Sensor.

    Tightening torque 

    : 0.9 ~ 1.2 kgf.m (8.5 ~ 11.5 Nm, 6.3 ~ 8.5 lb.ft)

  2. Reconnect the battery negative cable.
  3. After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals