Control Circuit Inspection

Check for open in harness
1. IG KEY OFF
2. Connect SMARTRA connector and disconnect PCM connector
3. IG KEY ON
4. Measure voltage between harness side immobilizer lamp terminal of PCM
  Specification: Batt.
5. Is the measured voltage within specifications?
YES
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for open or short in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.