July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Signal Circuit Inspection: Notes

Ignition "ON" & Engine "OFF".
Measure voltage between terminal 2 of the FLS harness connector and chassis ground. 1)
Specification: Approx. 0V

Fig 1: Measuring Voltage Between Terminal 2 Of FLS Harness Connector And Chassis Ground
Courtesy of HYUNDAI MOTOR CO.
Is resistance within the specification?
YES : --> Go to next step as below.

NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.