LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2008 >> Tiburon GT, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA-GSL 2.7L) >> DTC Troubleshooting Procedures >> DTC P0036 Ho2S Heater Control Circuit (Bank 1/Sensor 2) >> Component Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Component Inspection

  1. Measure resistance between terminals 3 and 4 of the sensor connector (Component side).

    Specification: 3~4Ω [at 20~24°C (68~75°F)]

    Fig 1: Measuring Resistance Between Terminals 3 And 4 Of Sensor Connector (Component Side)
    G03849397Courtesy of HYUNDAI MOTOR CO.
  2. Is resistance within the specification?

    YES: 

    • Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO: 

    • Check HO2S for contamination, deterioration, or damage. Substitute with a known-good HO2S and check for proper operation. If the problem is corrected, replace HO2S and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals