July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Component Inspection

Check Main Relay

IG "OFF"
Disconnect Main Relay
Measure the resistance between terminal 30 and 87 of main relay.

Measure the resistance between terminal 85 and 86 of main relay.

SPECIFICATION :

TERMINAL SPECIFICATION

Terminal	continuity
30 ~ 87	NO
85 ~ 86	YES (Approx. 70Ω ~ 120Ω)

Fig 1: Measuring Resistance Between Terminal 30 And 87 Of Main Relay

G05349736

Courtesy of HYUNDAI MOTOR CO.

Is the measured resistance within specification ?
YES
- Substitute with a known - good PCM and check for proper operation.
  If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM.

NO
- Substitute with a known - good Main Relay and check for proper operation.
  If the problem is corrected, replace Main Relay and go to "VERIFICATION OF VEHICLE REPAIR " procedure.