October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Component Inspection

IG "OFF" and disconnect ECTS connector.
Remove it.

Measure resistance between terminals 1 and 3 of ECTS connector as the temperature rises.

SPECIFICATION:

SPECIFICATION

Temp. (°C/°F)	Resistance (kΩ)	Temp. (°C/°F)	Resistance (kΩ)
-40 (-40)	48.14	40 (104)	1.15
-20 (-4)	14.13 ~ 16.83	60 (140)	0.59
0 (32)	5.79	80 (176)	0.32
20 (68)	2.31 ~ 2.59

Are the measured resistance within specification?
YES
- Clear DTC and Test-drive under enable conditions above-mentioned. After the test, If this DTC is set, recheck it thoroughly. If not, it is intermittent fault, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good ECTS and check for proper operation. If the problem is corrected, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.