October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Component Inspection

Check resistance of ECTS

IG "OFF" and disconnect ECTS connector.

Measure resistance between terminal 1 and 3 of ECTS connector. (Component Side)

SPECIFICATION:

SPECIFICATION

Temp. (°C/°F)	Resistance (kΩ)	Temp. (°C/°F)	Resistance (kΩ)
-40 (-40)	48.14	40 (104)	1.15
-20 (-4)	14.13 ~ 16.83	60 (140)	0.59
0 (32)	5.79	80 (176)	0.32
20 (68)	2.31 ~ 2.59

Fig 1: Measuring Resistance Between Terminal 1 And 3 Of ECTS Connector (Component Side)

G05321957

Courtesy of HYUNDAI MOTOR CO.

Is the measured resistance within specification ?
YES
- Clear DTC and Test-drive under enable conditions above-mentioned.
After the test, If this DTC is set, recheck it thoroughly. If not, it is intermittent fault, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO
- Substitute with a known - good ECTS and check for proper operation.
If the problem is corrected, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.