Component Inspection

Check coil antenna.
1. Ignition "OFF"
2. Disconnect SMARTRA.
3. Monitor resistance between terminal "1" and "2" of SMARTRA.
  Specification: Approx. 8.5Ω
  
  Fig 1: Monitoring Resistance Between Terminal "1" And "2" Of SMARTRA
  Courtesy of HYUNDAI MOTOR CO.
4. Is the measured resistance within specifications?
  YES
  
  Go to " 2Check SMARTRA" procedure.
  
  NO
  
  Check for open or short in antenna coil. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check SMARTRA
1. IGN "ON" & Engine "OFF"
2. Neutralize ECM and Register transponder key by scantool.
  NOTE: Pin code is required to Neutralize ECM and to Register transponder key.
3. Are Neutralizing and Registering completed normally?
  YES
  
  Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  
  NO
  
  Substitute with a known-good SMARTRA and check for proper operation.
  
  If the problem is corrected, replace SMARTRA and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.