LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2005 >> Tucson GLS, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> DTC Troubleshooting Procedure >> DTC P0560 Back-Up Line For Power >> Power Supply Circuit Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Power Supply Circuit Inspection

  1. Ignition "ON" Engine "OFF".
  2. Disconnect the "C24-2" of TCM connector.
  3. Measure the voltage between terminal "8" of the "C24-2" of TCM harness connector and chassis ground.

    Specification: Approx. B+

    Fig 1: Measuring Voltage Between Terminal 8 Of TCM Harness Connector And Chassis Ground
    G03763363Courtesy of HYUNDAI MOTOR CO.
  4. Is voltage within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. Refer to COMPONENT INSPECTION PROCEDURE .

    NO 

    • Check the Fuse 37-10A is installed or not blown.
    • Check for open in harness. Repair as necessary and refer to VERIFICATION VEHICLE REPAIR .
scientia non olet · About LEMON Manuals