Ground Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "ON" & Engine "OFF".
Disconnect the "OUTPUT SPEED SENSOR" connector.
Measure resistance between terminal "1" of the OUTPUT SPEED SENSOR harness connector and chassis ground.
Specification: approx. 0 Ω

Fig 1: Measuring Resistance Between Terminal 1 Of Harness Connector And Chassis Ground
Courtesy of HYUNDAI MOTOR CO.
Is resistance within specification?
YES
- Refer to COMPONENT INSPECTION .
NO
- Check for open in harness. Repair as necessary and refer to VERIFICATION OF VEHICLE REPAIR .
- If ground circuit in harness is OK, refer to 2 of COMPONENT INSPECTION procedure.