LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2005 >> Elantra GLS, 4D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle System) >> Automatic Transaxle System >> On-Vehicle Repair >> Input Shaft Speed Sensor Replacement >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Input Shaft Speed Sensor Replacement: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply a light coat of automatic transaxle fluid to the O-ring seal before installation.
  2. Install the input shaft speed sensor.
  3. Install the control cable mounting bracket.
  4. Connect the input shaft speed sensor connector.
  5. Install the clip of the control cable.
  6. Adjust the control cable to transaxle range switch and tight the transaxle manual lever to the control cable mounting nut. (see the TRANSAXLE RANGE SWITCH AND CONTROL CABLE ADJUSTMENT )
  7. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals