Rear Wheel Alignment
REAR WHEEL ALIGNMENTTOE-IN
Standard value
Rear toe-in:................................3 ± 2 mm (0.12 ± 0.079 inch)
NOTE: Release parking brake for the better measurement.
The rear suspension arm (B) mounting bolt should be turned an equal amount on both sides when adjusting.
Inside of the vehicle:............toe-in
Outside of the vehicle:...........toe-out
The scale has graduations of approximately 2.4 mm (0.09 inch) (single side toe angle equivalent to 14)
CAUTION: The eccentric bolt should be adjusted within a 90° range left and right from the center position.
CAMBER
Standard value
Rear camber:.....................................-41 ± 30
Rear camber is also pre-set at factory and can not be adjusted. If the camber measured is not within the standard value below, replace the bent or damaged parts.