LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2004 >> Accent GL, 2D Hatchback, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC Troubleshooting Procedures >> DTC P0134: O2 Sensor Circuit No Activity Detected (Bank 1/Sensor 1) >> Signal Circuit Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Signal Circuit Inspection

  1. Check for open in harness (signal)
    1. Ignition "OFF"
    2. Disconnect HO2S sensor connector
    3. Ignition "ON" & Engine "OFF"
    4. Measure voltage between terminal 2 of sensor harness connector and chassis ground.

      Specification: approximately 0.45V

      Fig 1: Measuring Voltage Between Terminal 2 Of Sensor Harness Connector And Chassis Ground
      G03851804Courtesy of HYUNDAI MOTOR CO.
    5. Is measure voltage within Specification?

      YES 

      • Go to "Check for open in harness (ground)" below.

      NO 

      • Open circuit between HO2S harness connector and PCM harness connector.
      • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  2. Check for open in harness (ground)
    1. Ignition "OFF"
    2. Disconnect HO2S sensor connector and PCM connector.
    3. Ignition "ON" & Engine "OFF"
    4. Measure resistance between terminal 1 of sensor harness connector and ECM harness connector.

      Specification: below 1Ω

      Fig 2: Measuring Resistance Between Terminal 1 Of Sensor Harness Connector And ECM Harness Connector
      G03851805Courtesy of HYUNDAI MOTOR CO.
    5. Is measure resistance within Specification?

      YES 

      NO 

      • Open circuit between HO2S harness connector and PCM harness connector.
      • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals