LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2004 >> Accent GL, 2D Hatchback, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC Troubleshooting Procedures >> DTC P0036: O2 Sensor Heater Control Circuit (Bank 1/Sensor 2) >> Power Circuit Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Power Circuit Inspection

  1. Ignition "OFF"
  2. Disconnect HO2S sensor connector.
  3. Ignition "ON" & Engine "OFF"
  4. Measure voltage between terminal 4 of sensor harness connector and chassis ground.

    Specification: approximately B+

    Fig 1: Measuring Voltage Between Terminal 4 Of Sensor Harness Connector And Chassis Ground
    G03851687Courtesy of HYUNDAI MOTOR CO.
  5. Is measure voltage within Specification?

    YES 

    NO 

    • Open or short circuit to chassis ground between HO2S harness connector and control relay.
    • Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: In case, when checking sensor voltage, the output voltage is 0V.
      • Possible cause: Blown fuse or open circuit in harness between E/C-J/BOX and terminal 4 of HO2S heater.
scientia non olet · About LEMON Manuals