System Specifications

SERVICE SPECIFICATIONS
Type Electronically Controlled 4-speed Full-Automatic
Gear Ratio
First 2.551
Second 1.488
Third 1.000
Fourth 0.685
Reverse 2.176
Final Gear Ratio 4.350
Speedometer Gear Ratio Drive 36/Driven 29
Transfer Shaft End Play 0 - 0.025 mm (0 - 0.0010 inch)
Transfer Idler Gear Preload 0.8 Nm (0.59 ft. lbs.)
Transfer Drive Gear End Play 0 - 0.06 mm (0 - 0.0024 inch)

TORQUE SPECIFICATIONS
Indicator Panel Mounting Screw 1.5 Nm Or More (1.1 ft. lbs. Or More)
Drain plug 30 - 35 Nm (22 - 25 ft. lbs.)
Pressure Check Plug 8 - 10 Nm (6 - 7 ft. lbs.)
Pulse Generator Mounting Bolt 10 - 12 Nm (7.5 - 8.5 ft. lbs.)
Bearing Retainer Screw 17 - 22 Nm (13 - 15 ft. lbs.)
Lock Plate Bolt 48 - 60 Nm (35 - 43 ft. lbs.)
Manual Control Lever Nut 17 - 21 Nm (13 - 15 ft. lbs.)
Manual Control Shaft Set Screw 8 - 10 Nm (6 - 7 ft. lbs.)
Detent Spring Bolt 10 - 12 Nm (7.5 - 8.5 ft. lbs.)
Transaxle Range Switch 10 - 12 Nm (7.5 - 8.5 ft. lbs.)
Sprag Rod Support Bolt 20 - 27 Nm (15 - 19 ft. lbs.)
End Clutch Cover 6 - 8 Nm (5 - 6 ft. lbs.)
Kickdown Servo Lock Nut 25 - 32 Nm (18 - 23 ft. lbs.)
Transfer Shaft Lock Nut 200 - 230 Nm (145 - 166 ft. lbs.)
Drive Plate-To-Converter Tightening Bolt 46 - 53 Nm (34 - 38 ft. lbs.)