LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2010 >> H3T Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.7L - DTC P1400 To DTC P2635 >> DTC P2440 >> Circuit/System Verification
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Verification

  1. Ignition ON, compare the scan tool Air Pressure Sensor pressure parameter to the BARO reading. The readings should be within 3 kPa (0.5 psi).
  2. Command the Secondary Air Solenoid Relay ON and OFF with a scan tool. You should hear an audible click as the relay is commanded ON and OFF.
  3. Command the Air Solenoid ON and OFF with a scan tool. Listen or feel for Air Solenoid operation. The Air Solenoid should respond to the scan tool commands. Repeat as necessary in order to verify Air Solenoid operation.
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals