LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2009 >> H3T Alpha >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 3.7L - Introduction) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Wiring Harness
    GM1350744Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (1).
    3. Fig 2: View Of Crankshaft Position Sensor
    GM858202Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor from the engine block.

    Discard the O-ring seals.

scientia non olet · About LEMON Manuals