LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2009 >> H3 Base, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement (LH8) >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    Fig 1: Battery Negative Cable Replacement (LH8)
    GM1901890Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the negative battery cable clip (2) from the lower half of the battery box.
  3. Remove the negative battery cable clip (3) from the battery tray.
  4. Remove the negative battery cable integral bolt (4) from the battery tray.
    5. Fig 2: Engine Wiring Harness Electrical Connector & Battery Current Sensor
    GM1901956Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the engine wiring harness electrical connector (6) from the battery current sensor (5).
    6. Fig 3: Negative Battery Cable Ground Bolt, Clip And Cable
    GM1901968Courtesy of GENERAL MOTORS CORP.
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the negative battery cable ground bolt (4).
  8. Remove the negative battery cable clip (2) from the engine wiring harness bracket.
  9. Lower the vehicle.
  10. Remove the negative battery cable clip (1) from the engine wiring harness bracket.
  11. Remove the negative battery cable (3) from the vehicle.
scientia non olet · About LEMON Manuals