LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2009 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition and Start Switch Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    WARNING: Refer to SIR Warning .
  1. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement .
  2. Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
  3. Remove the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  4. Disconnect the key buzzer from the ignition lock cylinder case.
    5. Fig 1: Releasing Tabs On Ignition Switch
    GM1413831Courtesy of GENERAL MOTORS CORP.
  5. Insert release tool J-42759  into the ignition lock cylinder case to release the tabs on the ignition/start switch. See Special Tools .
  6. Pull the ignition/start switch out of the ignition lock cylinder case.
  7. Disconnect the electrical connector from the ignition/start switch.
scientia non olet · About LEMON Manuals