LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2008 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine Controls And Fuel - 4.4L - DTC P0650 To DTC P2544) >> DTC P1682 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the Ignition 1 Signal and EC Ignition Relay Feedback Signal scan tool parameters to determine which is less than B+.
  2. Ignition OFF, remove the relay that corresponds to the scan tool parameter that is less than B+.
    3. IMPORTANT: 6 ohms or greater in the circuit/underhood fuse block will cause the DTC to set.
  3. Ignition ON, connect a 3A fused jumper wire between B+ and the appropriate ignition 1 circuit terminal. Verify that the applicable scan tool parameter displays B+.
    • Powertrain relay, ignition 1 circuit terminal X2 13
    • Run/crank relay, ignition 1 circuit terminal X1 19
    • If the applicable scan tool parameter is less than the specified value, test the ignition 1 circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the applicable relay.
scientia non olet · About LEMON Manuals