LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Conventional Brake System) >> Rear Brake Disc Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Rear Brake Disc Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Keep grease away from the brake disc/drum and the brake pads.
  1. Raise and support the vehicle (see LIFT AND SUPPORT POINTS ).
  2. Remove the rear wheels.
  3. Release the parking brake pedal fully.
  4. Remove and discard the brake hose clip (A) from the brake hose (B).
    NOTE:

    During installation, install a new brake hose clip.

    Fig 1: Identifying Brake Hose Clip And Brake Hose
    G05965393Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the brake hose bracket mounting bolts (A) from the knuckle.
    Fig 2: Brake Hose Bracket Mounting Bolt, Brake Caliper Bracket Mounting Bolts And Caliper Assembly With Torque Specifications
    G05965394Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the knuckle. To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage.
    NOTE:

    Do not twist the brake hose excessively.

  7. Remove the brake disc/drum flat screw (A).
    Fig 3: Brake Disc/Drum Flat Screw And Brake Disc/Drum With Torque Specifications
    G05965395Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the brake disc/drum (B) from the hub.
    NOTE:
    • Remove the access plug (C), then if necessary, turn the adjuster nut (D) with a flat-tip screwdriver until the shoes become loose.
    • If the brake disc/drum has stuck to the hub, thread two 8 x 1.25 mm bolts (E) into the brake disc/drum to push it away from the hub. Turn each bolt 90 degrees to prevent the brake disc/drum from binding.
  9. Install the brake disc/drum in the reverse order of removal, and note these items:
    • Before installing the brake disc/drum, clean the mating surface of the hub bearing unit and the inside of the brake disc/drum.
    • Adjust the parking brake (see PEDAL FREE PLAY ).
  10. Inspect the brake disc/drum runout (see RUNOUT ).
  11. Clean the mating surfaces of the brake disc/drum and the inside of the wheel, then install the rear wheel.
scientia non olet · About LEMON Manuals