Ignition Coil Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine cover.

Fig 1: Identifying Engine Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the ignition coil connectors (A), then remove the ignition coils (B).
FRONT

Fig 2: Front Ignition Coil Connectors With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.

REAR

Fig 3: Rear Ignition Coil Connectors With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the spark plugs and inspect them (see 2 ).
Apply a small amount of anit-seize compound to the plug threads, and screw the plugs into the cylinder head, finger-tight. Torque them to 22 N.m (2.2 kgf.m,16 lbf.f)
Install the ignition coils in the reverse order of removal.