LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2012 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Control >> Dust and Pollen Filter Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Dust and Pollen Filter Replacement

  1. Open the glove box, then open the glove box lid (A).
    Fig 1: Opening Glove Box Lid
    G06953732Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the lid (A) from the blower unit.
    Fig 2: Identifying Blower Unit Lid And Pollen Filter
    G06953733Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Pull out the dust and pollen filter (B).
  4. Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the blower unit.
  5. If the Maintenance Minder required replacing the dust and pollen filter, reset the Maintenance Minder (see MAINTENANCE MINDER™ ), and this procedure is complete. If the Maintenance Minder did not require the dust and pollen filter replacement, go to step  6.
  6. Turn the ignition switch to LOCK (0).
  7. Connect the HDS to the DLC (see step 2 on GENERAL TROUBLESHOOTING INFORMATION ).
  8. Turn the ignition switch to ON (II).
  9. Make sure the HDS communicates with the vehicle and ECM/PCM. If it does not communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  10. Go to the Individual Maintenance Item Reset (see MAINTENANCE SUB ITEMS ), and do the MAINTENANCE SUB ITEM 2 RESET.
scientia non olet · About LEMON Manuals