LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2011 >> Insight Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transmission (CVT) >> CVT Driven Pulley Pressure Control Solenoid Valve Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

CVT Driven Pulley Pressure Control Solenoid Valve Replacement

  1. Remove the lower valve body (see LOWER VALVE BODY REMOVAL/INSTALLATION  ).
  2. Disconnect the CVT driven pulley pressure control solenoid valve connector (A) and the inhibitor solenoid connector (B).
    Fig 1: CVT Driven Pulley Pressure Control Solenoid Valve And Inhibitor Solenoid Connector With Torque Specifications
    G06430124Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the CVT driven pulley pressure control solenoid valve (C), and remove the inhibitor solenoid (D) from the CVT driven pulley pressure control solenoid valve.
  4. Check that the filter (E) is in good condition, replace it if it is clogged or damaged.
  5. Remove the O-rings (F) from the inhibitor solenoid.
  6. Install new O-rings on the inhibitor solenoid, then install the inhibitor solenoid on a new CVT driven pulley pressure control solenoid valve.
  7. Install a new CVT driven pulley pressure control solenoid valve with the dowel pins (G) and the separator plate (H) on the lower valve body (I).
  8. Connect the CVT driven pulley pressure control solenoid valve connector and the inhibitor solenoid connector.
  9. Install the lower valve body (see LOWER VALVE BODY REMOVAL/INSTALLATION  ).
scientia non olet · About LEMON Manuals