LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2011 >> CR-Z Base, Automatic CVT >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> EPS System >> EPS Control Unit Removal/Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

EPS Control Unit Removal/Installation

  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  2. Remove the driver's kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
  3. Disconnect EPS control unit connector A (11P) and connector B (16P) by pushing the lock (C) and pulling down the lever (D) from the EPS control unit.
    Fig 1: Disconnecting EPS Control Unit Connector A (11P) And Connector B
    G06952977Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the EPS control unit.
  5. Install the EPS control unit (C).
    Fig 2: Pulling Up Lever Of EPS Control Unit Connector A (11P) And Connector B (16P) With Torque Specifications
    G06952978Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Pull up the lever (D) of the EPS control unit connector A (11P) and connector B (16P), then confirm the connector is fully seated to the EPS control unit.
  7. Install the driver's kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
  8. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  9. After installation, start the engine, allow it to idle, and turn the steering wheel from lock to lock several times. Check that the EPS indicator does not come on.
scientia non olet · About LEMON Manuals