LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2007 >> Ridgeline RTX >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Navigation System) >> System Diagnostic Mode >> Start-up procedure and Diagnosis Menu
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Start-up procedure and Diagnosis Menu

WARNING: This page is about a different car, the 2008 Honda Pilot, 2007 Honda Pilot, and 2006 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the ON (II) position.

    Press and hold the Menu, the Map/Guide, and the Cancel buttons. Keep them pressed for approximately 5 seconds or jumper the 2-pin SCS service connector. The display screen then goes directly to the Diagnostic Menu.

    NOTE:
    • This only allows access to the diagnostic screens. All other Navigation functions are disabled.
    • When you finish troubleshooting, make sure you remove the SCS service connector.
      Fig 1: Screen Display - Diagnosis Menu Screen
      G05594911Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. After the display changes to the Diagnostic Menu, select the item you want to check, and the test will start. To return to the previous screen, select "Return".
    • Navi System (Link)
    • Monitor Check
    • Unit Check
    • Car Status
    • F-CAN
    • GPS Information
    • Yaw Rate
    • Tire Calibrate
    • Functional Setup
    • Version