Resetting the Maintenance Information Display

NOTE:

The vehicle must be stopped to reset the display.
If a required service is done and the display is not reset, or if the maintenance display is reset without doing the service, the system will not show the proper maintenance timing. This can lead to serious mechanical problems because there will be no accurate record of when the required maintenance is needed.
The engine oil life and the maintenance item(s) can be reset independently only with the HDS.

Turn the ignition switch to the ON (II) position.
Push the SELECT/RESET knob repeatedly until the engine oil life indicator is displayed.
Press and hold the SELECT/RESET knob for about 10 seconds. The engine oil life indicator and the maintenance item code(s) will blink.
NOTE: If you are resetting the display when the engine oil life is more than 15%, make sure any maintenance item(s) requiring service are done before resetting the display.
Press and hold the SELECT/RESET knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to "100."

Fig 1: Identifying Oil Life At 100 Percent Displayed ('07-08 Models)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Identifying Oil Life At 100 Percent Displayed ('09-11 Models)
Courtesy of AMERICAN HONDA MOTOR CO., INC.