Cruise Control Set/Decel, Resume/Accel, Cancel Switch Test/Replacement

WARNING: This page is about a different car, the 2006 Honda CR-V and 2005 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.

Remove the two screws, then remove the switch.

Fig 1: Removing Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or both positions, replace the switch.
  
  Fig 2: Terminals Switch Position Specification Table
  Courtesy of AMERICAN HONDA MOTOR CO., INC.