LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2006 >> Odyssey EX-L >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Supply System >> Fuel Pressure Relieving >> With the HDS
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

With the HDS

  1. Make sure you have the anti-theft codes for the radio and the navigation system (if equipped) then write down the customer's radio station and XM radio channel presets.
  2. Remove the fuel fill cap, and relieve the pressure in the fuel tank.
  3. Turn the ignition switch ON (II).
  4. From the INSPECTION MENU of the HDS, select Fuel Pump OFF, then start the engine and let it idle until it stalls.
  5. Turn the ignition switch OFF.
    NOTE:
    • Do not allow the engine to idle above 1,000 rpm or the PCM will continue to operate the fuel pump.
    • A DTC or a Temporary DTC may be set during this procedure. Check for DTCs, and clear them as needed (see GENERAL TROUBLESHOOTING INFORMATION ).
  6. Turn the ignition switch OFF.
  7. Disconnect the negative cable from the battery.
  8. Remove the quick-connect fitting cover (A).
    Fig 1: Removing Quick-Connect Fitting Cover
    G03704559Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Check the fuel quick-connect fitting for dirt, and clean it if needed.
  10. Place a rag or shop towel over the quick-connect fitting (A).
    Fig 2: Placing Rag Or Shop Towel Over Quick-Connect Fitting
    G03704560Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the retainer tabs (C) with the other hand to release them from the locking tabs (D). Pull the connector off.
    NOTE:
    • Be careful not to damage the line (E) or other parts.
    • Do not use tools.
    • If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
    • Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
    Fig 3: Disconnecting Quick-Connect Fitting
    G03704561Courtesy of AMERICAN HONDA MOTOR CO., INC.
  12. After disconnecting the quick-connect fitting, check it for dirt or damage (see step 4 in FUEL LINE/QUICK-CONNECT FITTING REMOVAL  .
  13. Reconnect the negative cable to the battery, then do this:
    • Do the power window control unit reset procedure (see RESETTING THE POWER WINDOW CONTROL UNIT ).
    • Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station and XM radio channel presets.
    • Set the clock.
scientia non olet · About LEMON Manuals