September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Ect Sensor 1 Replacement
- Drain the engine coolant (see
COOLANT CHECK
).
- Remove intake manifold cover (see step 1 on
IGNITION COIL REMOVAL/INSTALLATION
).
- Disconnect ECT sensor 1 2P Connector (A).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Remove ECT sensor 1 (B).
- Install the sensor in the reverse order of removal with a new O-ring (C), then refill the radiator with engine coolant (see
COOLANT CHECK
), and bleed air from the cooling system with the heater valve open.