September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Back-Up LIGTH Switch
- Disconnect the back-up light switch connector. See Fig 1
.
- Check for continuity between the No.1 and No.2 terminals of back-up light switch 2-pin connector. There should be continuity when the shift lever is in the reverse.
- If necessary, replace the back-up light switch. Apply liquid gasket (P/N 08718-0001) to the switch threads, and install the switch on the transmission housing.
Courtesy of AMERICAN HONDA MOTOR CO., INC.