LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2000 >> Accord DX, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Fuel System & Emission Systems (4-CYL) >> How to Set Readiness Codes >> EGR Monitor Code
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

EGR Monitor Code

NOTE:
  • Do not turn the ignition switch OFF.
  • When the battery negative cable is disconnected, all readiness codes are cleared.
  1. Connect the scan tool to the Data Link Connector.
  2. Start the engine, and hold it at 3,000 RPM with no load (in Park or neutral) until the radiator fan comes on.
  3. Drive at a steady speed with the transmission in D4 position between 50-62 mph (80-100 km/h) for more than 10 seconds.
  4. With the A/T in D4 position or M/T in 5th gear, decelerate from 62 mph (100 km/h) by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this procedure, repeat steps 3 and 4.
  5. Check for the readiness code with the scan tool.
scientia non olet · About LEMON Manuals