Engine Controls - Tests W/Codes 1.6 & 1.8L: Introduction

Most engine control problems result from mechanical failures, poor electrical connections, or damaged vacuum hoses. Before condemning the computer system, perform checks and inspections covered in basic diagnostic procedures in the BASIC TESTING article. Failure to do so may result in lost diagnostic time.

If no faults were found while performing basic diagnostic procedures, proceed with diagnostic procedures under SELF-DIAGNOSTIC SYSTEM . If no Diagnostic Trouble Codes (DTCs) are present, and driveability problems exist, proceed to the TESTS W/O CODES article for diagnosis by symptom (i.e., ROUGH IDLE, NO START, etc.). If only intermittent DTCs are present, go to the TESTS W/O CODES article.