LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Geo >> 1995 >> Metro Base, 2D Hatchback >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - 1.0L 3-CYL >> Ignition System >> Distributor >> Removal & Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal & Installation

  1. Disconnect negative battery cable. Remove distributor cap. See Figure. Mark distributor-to-engine position and distributor rotor-to-distributor housing position for installation reference. Remove distributor harness connector and 2 hold-down bolts. Remove distributor.
  2. DO NOT rotate crankshaft with distributor removed, or reference marks will be incorrect. To install distributor, use reference marks and reverse removal procedure. Install mounting bolts. DO NOT tighten mounting bolts fully, until timing is reset. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals