Repair Procedures: Inspection

Turn the ignition switch OFF.
Disconnect the console temperature control actuator and console ON/OFF actuator connector.

Verify that the console temperature actuator and console ON/OFF actuator operates to the cool position when connecting 12V to terminal 7 and grounding terminal 3.

Verify that the temperature control actuator operates to the warm position when connected in reverse.

Courtesy of HYUNDAI MOTOR AMERICA

CONSOLE TEMPERATURE ACTUATOR SPECIFICATIONS

Terminal	Function
1	-
2	-
3	Warm position
4	Sensor ground
5	Feedback signal
6	Sensor power (+5V)
7	Coll position (Console OFF)

CONSOLE TEMPERATURE (A) ACTUATOR SPECIFICATIONS

Terminal	Function
1	-
2	-
3	Warm position
4	Sensor ground
5	Feedback signal
6	Sensor power (+5V)
7	Coll position

CONSOLE ON/OFF ACTUATOR SPECIFICATIONS

Terminal	Function
1	-
2	-
3	Console (OFF)
4	Sensor ground
5	Feedback signal
6	Sensor power (+5V)
7	Console (ON)

Connect the console temperature control actuator and console ON/OFF actuator connector.
Turn the ignition switch ON.
Check the voltage between terminal 4 and 5.
If the measured voltage is not within specification, substitute with a known-good console temperature actuator and console ON/OFF actuator and then check for proper operation.
Replace the console temperature actuator and console ON/OFF actuator if it is proved that there is a problem with it.