Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

Install the parking switch. When installing, tighten the inhibitor assembly mounting bolts (A) loosely to allow any necessary adjustments to be made.

Fig 1: Locating Inhibitor Assembly Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking release lever (B).
Install the SST No.: 09480-D2100 or 0.1969in. (5mm) bolt after setting parking release lever (B) in the "P".

Fig 2: Installing Parking Release Lever
Courtesy of HYUNDAI MOTOR AMERICA
Tighten mounting nut (A) of the parking release lever to the specified torque.
Tightening Torque:

13.7 - 17.7 N.m (1.4 - 1.8 kgf.m, 10.1 - 13.0 lb-ft)
Tighten the bolt (B) to the specified torque.
Tightening Torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Fig 3: Tightening Mounting Nut Of Parking Release Lever
Courtesy of HYUNDAI MOTOR AMERICA
Remove the SST No.: 09480-D2100 or 0.1969in. (5mm) bolt.
Install the cross member (A).

Fig 4: Installing Cross Member
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking release cable by installing the fastener (A).
Connect the inhibitor switch connector (B).

Fig 5: Connecting Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Connect the negative (-) battery cable.