Actuator Actuation
- Plug GDS to Data Link Connector (DLC).
- Turn "ON" the ignition switch
- Perform "Actuation" using the GDS.
- Select "Bleeding Control Command" on the "Actuation" menu.
- See if the bleeding succeeded or not.
YES
- Replace the transfer case with an usable one and check for proper operation. If It works normally, replace the transfer case. Then go to "VERIFICATION OF VEHICLE REPAIR ".
* After replacing the transfer case, go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Go to "VERIFICATION OF VEHICLE REPAIR ".
- Replace the transfer case with an usable one and check for proper operation. If It works normally, replace the transfer case. Then go to "VERIFICATION OF VEHICLE REPAIR ".