Check Short In Signal Circuit
- Turn "OFF" the ignition switch. Disconnect 'CRUISE REMOCON SWITCH' connector and ECM connector.
- Check resistance between 'Signal (Cruise SW)' terminal and 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness connector.
- Check resistance between 'Signal (Cruise SW)' terminal and 'Ground (Cruise SW)' terminal of 'CRUISE REMOCON SWITCH' harness connector.
Specification : Infinite ∞Ω
- Is the measured value within specification?
YES
- Go to "CHECK OPEN IN SIGNAL CIRCUIT " as follows.
NO
- Repair short in signal circuit, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.