Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the floor console assembly.
(Refer to Floor Console - "FLOOR CONSOLE ASSEMBLY ")
- Remove the floor console armrest.
(Refer to Console Armrest )
- Loosen the mounting screws (A) located on the upper and rear sides of rear console cover.
- Disconnect the connector (A).
- Install in the reverse order of removal.
information
- Make sure the connector is connected properly.
- Replace any damage clips.