Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Position a NEW steering gear boot inner clamp (1) on the steering gear boot (2).
Position the steering gear boot (2) on the steering gear.
Courtesy of GENERAL MOTORS COMPANY

Use the CH-22610 pliers (1) to tighten the steering gear boot inner clamp (2).
Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Outer Clamp (2) - Install
Steering Linkage Inner Tie Rod Nut (1) - Install
Steering Linkage Outer Tie Rod - Install - Steering Linkage Outer Tie Rod Replacement (With ZR2)
Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment