Theft Deterrent Module Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 GMC Sierra 3500 HD, 2017 GMC Sierra 2500 HD, 2017 GMC Sierra 1500, 2017 Chevrolet Silverado 3500 HD, and 2017 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Theft Deterrent Module

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Ignition Lock Cylinder Replacement NOTE: The steering wheel is shown removed for clarity only. It is NOT necessary to remove the steering wheel to perform the theft deterrent module replacement procedure.
1	Theft Deterrent Module Bolt CAUTION: Refer to Fastener Caution . Tighten 2.5 (22 lb in)
2	Theft Deterrent Module Procedure Disconnect the electrical connector. Release the retaining tabs and remove the theft deterrent module from the ignition lock cylinder case. Perform the necessary programming and setup procedure:Control Module References

Callout

Component Name

Preliminary Procedure
Ignition Lock Cylinder Replacement

NOTE:

The steering wheel is shown removed for clarity only. It is NOT necessary to remove the steering wheel to perform the theft deterrent module replacement procedure.

Theft Deterrent Module Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
2.5 (22 lb in)

Theft Deterrent Module

Procedure

Disconnect the electrical connector.
Release the retaining tabs and remove the theft deterrent module from the ignition lock cylinder case.
Perform the necessary programming and setup procedure:Control Module References