LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2008 >> Acadia SLE, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC P0562 >> Circuit/System Testing
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Circuit/System Testing

  1. Ignition OFF, disconnect the X2 harness connector of the ECM. Verify that there is less than 1.0 ohm between the ground circuit X2 terminal 73 and the negative battery terminal.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  2. Ignition ON, test for 11-14 volts between the ECM battery positive voltage circuits X2 terminals 13 and 18, and the ground circuit X2 terminal 73.
    • If not within the specified range, test the battery positive voltage circuits for a short to ground or an open/high resistance.
  3. If all circuits test normal, test or replace the ECM.
scientia non olet · About LEMON Manuals