July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .

Fig 1: Removing & Installing Stabilizer Shaft Link Retaining Nut

GM750841

Courtesy of GENERAL MOTORS CORP.

Remove the stabilizer shaft link lower retaining nut.
Remove the stabilizer shaft link from the lower control arm.

Fig 2: Removing & Installing Lower Shock Bolts

GM742959

Courtesy of GENERAL MOTORS CORP.

Remove the shock assembly lower retaining bolts (1).

Fig 3: View Of Outer Tie Rod-To-Steering Knuckle And Retaining Nut

GM794579

Courtesy of GENERAL MOTORS CORP.

Remove the outer tie rod to the steering knuckle retaining nut.

Fig 4: Removing Outer Tie Rod Assembly From Steering Knuckle

GM643351

Courtesy of GENERAL MOTORS CORP.

Using J 24319-B disconnect the outer tie rod from the steering knuckle.

Fig 5: Identifying Anti-Lock Brake Wiring Harness At Lower Control Arm

GM802031

Courtesy of GENERAL MOTORS CORP.

Remove the ABS wire harness from the lower control arm.

Fig 6: Removing Lower Control Arm Mounting Nuts

GM750908

Courtesy of GENERAL MOTORS CORP.

Remove the lower control arm mounting nuts.
Remove the lower control arm mounting bolts.
Lower and support the lower arm control to gain access to the lower ball joint.

Fig 7: Removing & Installing Steering Knuckle Ball Joint

GM750956

Courtesy of GENERAL MOTORS CORP.

Remove the lower ball joint retaining nut and discard.

Fig 8: View Of Special Tool J 43631

GM750829

Courtesy of GENERAL MOTORS CORP.

Using J 43631 separate the lower ball joint from the steering knuckle. See Special Tools .
Remove the lower control arm from the vehicle.