LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2007 >> Acadia SLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Wiper System & Washer System) >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor
    GM1471742Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor. Refer to Wiper Motor Replacement (Legacy) .
  2. Connect the electrical connector to the wiper motor.
  3. Connect the clip retaining the electrical harness to the wiper module.
    4. Fig 2: View Of Wiper Drive System Module
    GM1471736Courtesy of GENERAL MOTORS CORP.
  4. Position the wiper module assembly into the plenum.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the fasteners attaching the wiper module assembly to the plenum.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  7. Install the wiper arms. Refer to Wiper Arm Replacement (Legacy) .
  8. Inspect the washers for proper operation.
scientia non olet · About LEMON Manuals