LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1660 (Lighting Systems) >> Repair Instructions >> Tail Lamp Circuit Board Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulbs to the tail lamp circuit board.
  2. Position the tail lamp circuit board to the tail lamp.
    Fig 1: Removing/Installing Tail Lamp Circuit Board
    GM732917Courtesy of GENERAL MOTORS CORP.
  3. Hold the top 2 locking tabs apart while pushing the tail lamp circuit board into place.
  4. Hold the bottom 4 locking tabs apart while pushing the tail lamp circuit board into place.
  5. Verify that the circuit board is fully seated with the locking tabs fully seated.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the 2 tail lamp circuit board retaining screws.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  7. Install the tail lamp. Refer to Tail Lamp Replacement .
scientia non olet · About LEMON Manuals